Page 2 of 2
Posted: Wed Sep 02, 2009 9:03 pm
by dypsis
Every time I try to type with v4.3.1 Dev, I get the same message as in previous post.
But at least Alt Codes work.
Posted: Thu Sep 03, 2009 3:57 am
by Instructor
But I get a popup error message.
It says.
0.Char=[-2]
Do you sure your NumLock is ON??
Posted: Thu Sep 03, 2009 4:38 am
by dypsis
Instructor wrote:But I get a popup error message.
It says.
0.Char=[-2]
Do you sure your NumLock is ON??
Oops.
With Num Lock on, the error messages are this when I press Alt+175.
0.Char=[175]
1.Char=[¯][175]
2.Char=[¯][175]
3.Char=[¯][175]
It must have been off this morning.
But it is not working with Num Lock on.
Posted: Thu Sep 03, 2009 4:43 am
by Instructor
Finally. Be attentive. Now press Alt+187 or Alt+0187 and you get your character (use 4.3.0).
Posted: Thu Sep 03, 2009 8:20 pm
by dypsis
Instructor wrote:Now press Alt+187 or Alt+0187 and you get your character (use 4.3.0).
Why has this changed now?
I like the standard Alt Codes as posted on many sites.
If I use Notepad or MS Word, I can use Alt+175. Even if I use AkelPad 4.2.6, I can use the standard codes.
Sorry, but I am used to using certain Alt codes, now I don't know what I am doing with this new version.
Posted: Fri Sep 04, 2009 3:19 am
by Instructor
dypsis
Test version. Now decimal input started after two "Num 0".
Posted: Fri Sep 04, 2009 4:09 am
by dypsis
Instructor wrote:dypsis
Test version. Now decimal input started after two "Num 0".
No good.
I am getting error messages, and Alt+175 produces ¯
0.Char=[175]
1.Char=[¯][175]
2.Char=[¯][175]
3.Char=[¯][175]
Posted: Fri Sep 04, 2009 4:24 am
by Instructor
dypsis
Clear cache of your browser. AkelPad.exe file time - 04.09.2009 9:16.
Posted: Sun Sep 06, 2009 10:24 pm
by dypsis
Instructor wrote:dypsis
AkelPad.exe file time - 04.09.2009 9:16.
Thank you.
It seems to be fixed.